This is especially useful for Signal Source/Network Analyzer calibration and power references as well as EMC applications. External trigger will enable accurate trigger of small signals close to the signal noise floor. With the built-in trigger in connection on the U8480-series power sensors you can connect an external trigger signal from a signal source or the device under test directly to the USB sensor through a standard BNC to SMB cable. The U8480 series is supported by the Keysight BenchVue software. BenchVue makes it easy to control your power meter to log data and visualize measurements in a wide array of display options without any programming. Simply connect the sensor to your PC installed BenchVue BV0007B Power Meter/Sensor Control and Analysis app to perform average power measurement and analysis. Features Frequency range of DC/10MHz to 18 GHz Fastest measurement speed for thermocouple sensor, > 400 readings/s (free run/fast buffer mode) Best-in-class power linearity of less than 0.8% Wide dynamic range from -35 dBm to +20 dBm Accurate calibration and traceability to US National Institute of Standards and Technology (NIST) or National Physical Laboratory (NPL) BenchVue software enabled